Chọn một quốc gia hoặc khu vực khác để xem nội dung cho vị trí của bạn.
United States
Idler Pulley Units
Idler pulley units are tensioning systems for belt drives and idler units.
They:
The ready-to-fit units comprise deep drawn, profiled sheet steel pulley halves riveted together and deep groove ball bearings. Pulleys of larger diameters are additionally welded together. A lead chamfer on the pulley profile prevents damage to the belt. Due to the sheet steel construction, the additional rotating masses and the out-of-balance masses generated are low.
Type A is suitable for V-belts, type B for flat, V and round belts, type D for round belts, steel cables and hemp ropes.
They:
- increase the wrap angle in belt drives and can therefore support higher power levels or allow smaller units to be used
- Compensate for belt stretch resulting from operation
- Allow shorter center distances
- Reduce the wear on the belt drive
The ready-to-fit units comprise deep drawn, profiled sheet steel pulley halves riveted together and deep groove ball bearings. Pulleys of larger diameters are additionally welded together. A lead chamfer on the pulley profile prevents damage to the belt. Due to the sheet steel construction, the additional rotating masses and the out-of-balance masses generated are low.
Type A is suitable for V-belts, type B for flat, V and round belts, type D for round belts, steel cables and hemp ropes.
Xin vui lòng chờ…
Sản phẫm (0)
Không có kết quả tìm kiếm nào được tìm thấy.
Không tìm thấy những gì bạn đang tìm kiếm?
Liên hệ chúng tôiTiếp tục duyệt